Device designers
Passive Designer
Describe a passive component in a prompt or by voice, approve the specifications, and receive layout, netlist and simulated results.
Private pilot
Launch is not available yet. The application exists and runs in a private pilot. Hosted access through this site opens once sign-in and entitlement checks are verified.
What you do
You describe the passive device in a prompt window or by voice conversation with a voice orb. The designer lists the specifications and asks for your approval, generates the netlist and GDS layout and prepares the simulation setup. When you approve, it sends the simulation (MEEP, FDTDX or MEOW) to cloud compute and displays the results when the work completes.
Every designer works the same way. It takes a design request through a prompt window or by voice conversation with a voice orb, lists the specifications and asks for your approval, generates the netlist and GDS and prepares the simulation setup, and, once you approve, sends the simulation to a local or remote compute server and shows the results when the work completes.
Workflow
State the device, platform and targets in a prompt or by voice.
Review the listed specifications and the prepared netlist, GDS and solver setup. Revise dimensions, PDK or solver, then approve.
The simulation is sent to compute. Ask for status at any time.
Results are displayed when the work completes.
Inputs
- Written prompt or voice conversation
- PDK selection: generic gdsfactory PDK, SiEPIC EBeam (UBC) or Luxtelligence on the hosted service
- Explicit dimensions, wavelength range and solver choice where you have them
Outputs
- Layout (GDS) and netlist
- Simulation setup for MEEP, MEOW or FDTDX
- Simulation results when the work completes
Representative use case
A 1×2 MMI splitter for the C-band on a 220 nm SOI platform: ask for balanced splitting across 1500–1600 nm, review the proposed MMI length and taper widths, then approve a simulation.
How to read a result
AI guidance proposes geometry and setup. Solver outputs come from the named solver and carry its convergence status. Neither is a substitute for human engineering review before fabrication.
- Availability
- Private pilot. The application exists and runs in a private pilot. Hosted access through this site opens once sign-in and entitlement checks are verified.
- Technology
- Open-source workflow: GDSFactory and KLayout for layout, with MEEP, MEOW and FDTDX solver interfaces. Supported PDKs on the hosted service are the generic gdsfactory PDK, SiEPIC EBeam (UBC) and Luxtelligence. Simulations are dispatched to cloud compute.
Other designers
Photonic Architect
Consult a photonics AI about architecture choices, trade-offs, design strategy and prototyping, by prompt or by voice.
Product details →In developmentActive Designer
Intended to work like the Passive Designer, with the role of designing active photonic devices.
Product details →In developmentLayout Designer
Intended to work like the Passive Designer, with the role of laying out photonic circuits.
Product details →In developmentPackage Designer
Intended to work like the Passive Designer, with the role of designing how a photonic chip is packaged.
Product details →