Conceptual 3D artwork · illustrative fields

01 — Photonic Intelligence

Design and simulate photonic devices with AI

Describe a device in a prompt or by voice. Photonic Intelligence lists the specifications for your approval, prepares the layout and simulation setup, and shows the results when the work completes.

02 — Field propagation

Watch the light decide

Inside a multimode interference splitter, guided modes beat against each other until one input becomes two. Every device on this die is drawn in your browser, with light animated from an analytic mode model.

  • 1×2MMI self-imaging
  • 5modes summed
  • LiveWebGL shader

03 — The circuit

Modulate. Filter. Detect.

A Mach-Zehnder modulator writes data onto the carrier under travelling-wave electrodes. Four thermally tuned rings pick wavelengths off the bus and hand each one to its own photodiode.

  • MZMGSG electrodes
  • 4 λring filter bank
  • Ge PDdrop ports

04 — Fabrication

From wafer to waveguide

Scroll through a silicon-on-insulator process: resist, exposure, etch, cladding and metal. Layer thicknesses are exaggerated so each step reads clearly.

Step 1 / 8 · SOI wafer

05 — Co-packaged optics

Inside an optical engine

The engine comes apart layer by layer: substrate, solder, photonic IC, bond interface, electronic IC, carrier, optical connector and thermal cap. The stack is reconstructed from public disclosures, and every part is tagged as sourced or inferred.

06 — On the bench

Then it meets the lab

A wire-bonded die on a test board, fibres aligned on positioners, a tunable laser on one side and a spectrum analyser on the other. Drop in a device and sweep it yourself.

Design tools

Five applications. One way of working.

Each designer takes a request by prompt or by voice, lists the specifications and waits for your approval, then sends the simulation to a compute server and shows the results. Only the Passive Designer is running today, in private pilot. Start with the architect when the question is bigger than one device.

What a result looks like

A prompt in. Evidence out.

Each run keeps AI guidance, solver output and human review apart, so you always know what a number rests on.

  1. Requirements

    “1×2 MMI splitter, 220 nm SOI, balanced across 1500–1600 nm.”

  2. Prepared setup

    Layout, material stack and solver configuration, shown for review before anything runs.

  3. Solver run

    The named solver executes. Convergence status travels with the result.

  4. Report

    Plots, compact model and assumptions, ready for engineering review.