Design Library · Reference design

1×2 MMI splitter

One input, two balanced outputs. Light entering the centre of a multimode section excites its even modes, which re-image as two spots at three-eighths of the beat length.

Validation status: draft · no approved results published

About the Passive Designer

“Open in Designer” is enabled once the Passive Designer supports loading this example through a verified launch contract.

Conceptual artwork. The interference pattern is an analytic five-mode sum, not a solver field.
This page is the approved template with the first example's structure in place. Fields marked “pending” will be filled from an approved Passive Designer run. No number on this page is a simulation result yet.

Geometry

MMI width
Pending approved run
MMI length
Pending approved run
Port taper
Pending approved run
Output pitch
Half the MMI width, by symmetry of the two-fold image
Layout
GDS and netlist attached on publication

Material stack

Platform
220 nm silicon on insulator
Cladding
Silicon dioxide
Material models
Stated with source on publication

Assumptions

  • Fundamental TE mode at the input.
  • Ideal vertical sidewalls unless stated.
  • Further assumptions listed with the published run.

Solver configuration

Solver
Named solver and version, pending
Dimensionality
Pending
Wavelength sweep
Pending
Mesh / modes
Pending

Convergence

The check applied, the quantity tracked and whether the run passed. A run that did not converge is published as such.

Results

Per-port transmission
Pending approved run
Imbalance
Pending approved run
Excess loss
Pending approved run
Field plots
Pending approved run

Evidence

Simulation pending   Cross-solver not yet run   Measurement none